Customer reviews about Göldo Screws for Bass Pickups SB

DB

Two nice sets of screws but ...

Dr Bassman 16.12.2019

A while back, I bought a Harley Benton B-450 QTB bass from Thomann. It's an amazing instrument but unfortunately it lost one of the fixing screws for its neck pickup. I later found out that this is a reasonably common problem because these screws are not always tightened properly during manufacture. Hence, they have a tendency to fall out.

Anyhow, to cut a very long story short, Thomann kindly sent me two packets of these screws in order that I might rectify the problem with my bass. Don't get me wrong, they are nice enough screws (so 5 stars for quality) BUT they are too long for my B-450 QTB; which is only one star overall i.e.. they are of little use to me.

Seriously, sometimes I just want to scweam and scweam and scweam and scweam ...

1

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

T

Works fine, good quality.

TrEr 09.06.2020

I got these because according to the specs they were slightly longer than most standard pickup screws. I have a bass with slightly deeper routing than normal and none of the spare screws I had were long enough to adjust the pickups correctly.

These screws did the trick. They're only 2-3 mm longer but it was enough to get the pickups where I wanted them.

Quality wise they're perfectly fine. Nothing exceptional, they're simply good quality screws.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

WB

Carpenters choice.

Woodwork Barn 17.10.2017

The Screws were used in an experimental P Bass which I made from Oak! (being a carpenter, I get a lot of good quality off-cuts). When new, being decent quality, the screws drove into the hard wood perfectly. However, about a month later when I came to adjust the height of my pick-ups, two of the screws refused to budge and I ended up rounding the heads off. This was through no fault of the screws but was due to the high tannin content in Oak which can eat steel. As a carpenter I should have realised this earlier. I managed to remove them cleanly with pliers in the end!

In summary;
Good quality screws, perfect for use in normal tone woods, will be buying more very very soon but oiling them well before they go back in!
Oak.... Excellent tone wood, but a bit heavy and likes to eat steel! :)

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

A

Perfect for Bartollini pickups

Anonymous 15.09.2016

just what I needed, perfect replacement for Bartollini pickups screws

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

S

Screws for Bass pickup

SouledOut 09.05.2022

Ordered these to replace the screws on a fender P bass but these are longer and a tiny bit smaller that the stock fender P bass pickup screws.
Just keep in mind to order the correct size for your pickup.

It's too soon to tell if the quality is good.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

JK

Value for money

James K. 01.05.2013

I bought these to replace screws in EMG jazz pickups which had oxidised over the years (the black screws now had white powdery oxidation on the heads), these are a perfect replacement same length same thickness and same thread, the bass now looks good as new and they fit perfectly!

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

B

Work perfectly

BruceB 17.06.2024

I needed to reposition the pickups on a restoration project, and these slightly longer than OEM screws worked perfectly with some foam to relocate the pickups at the perfect distance from the strings when I set up the guitar. Recommended.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

A

Good quality screws

Anonymous 09.09.2014

The finish is nice and they're long enough for most instruments. The heads are pretty sturdy but don't get too excited with your screwdriver or you'll end up ruining them.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

A

Good

Anonymous 19.09.2016

No problems with them yet. Had for almost a year, no rust.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

Göldo Screws for Bass Pickups SB

117 Customer ratings

You have to be logged in to rate products.

5 Reviews

Served with love!

Göldo Screws for Bass Pickups SB

117 Customer ratings

You have to be logged in to rate products.

5 Reviews