I have had it for 5 days now and I already played it for 30 hours or so. Nicely setup - good for fingerpicking but a little too low action for the slide - it is not bad at all. Built quality seems good, although I have some doubts. Nice sounding and nice looking guitar, but there are some things that are not as they should be. First - the nut. It is a bleached bone nut and that is good, but it is really sharp on the fretboard side, after 3-4 hours of playing it started to hurt my finger. It will need sanding and polishing of the nut. Also, the frets are pretty sharp on the outer edges, not really as they should be. They are also rough so it is not easy to bend strings - they will need sanding on the edges and polishing. The fifth fret is a little hight - poorly installed - but I can live with that for now.
It seems that the cone hole in the body is not aligned with the neck. Since these are CNC mashined I wonder how can this happen. The cone is not in the center - there is a gap on one side (6-7mm) and no room on the other side, I even see some minor warping of the cone edge, but it should not affect the sound. They had to push the aluminum cone tight on one side to align the strings and the biscuit with the neck. I hope I will not have dimensions issues when I try to install a replacement cone after some time, if I do - some sanding may be required - again.
Finish has some minor flaws, but I don t mind that.
Tuners seem to be good, no issues there
I know it is a fairly cheap resonator, but it could be better for the money.
Hopefuly, after some work and a little setup it will be a road worthy instrument.
