Harley Benton Parts Roller String Tree Chrom

This fit nicely on my strat style guitar and seems to fulfill its purpose, the build quality is fair and it looks alright. Howevere there was no screw included, and this needs to be kept in mind. If you are replacing an existing string tree this should not be an issue, but if you want to add a new one you need to find a suitable screw as well.

Like has been said before, these are VERY tall. Depending on the guitar you are putting them on they may work well, they may not.

But if put on a guitar that has the correct headstock angle, they work REALLY well! The build quality and finish are quite satisfactory. And the retrofit should be quite easy!

Generally they will work MUCH better than the old “Butterfly” string trees you will probably be replacing with these.

1. screw not included
2. feels a little taller than what is needed, I guess it would be helpful if it was shorter in height.
Otherwise, seems pretty good.

Great upgrade from the usual string trees on affordable guitars, but the quality could be better. The little axis that can turn is quite loose, so it can wobble around even with the string tensioning it. Also, they are a bit taller than regular string trees and won't provide the same angle for the strings. Not sure if that's a disadvantage regarding tuning stability though.

It's little disappointing that there is no screws. I have no suitable screws at home and screw shops are closed on pandemic...
Not a big problem though.
The Second I have to say - trees are high. They should be lower to place them to the same holes as the stock ones. Sand them down 1-2mm.

This tiny part is good quality and does it's job very well. There's just one complaint I can make, and it's not about the product, but the possible options. Because of it's relatively tall design, it cannot be used as an upgrade for many guitars where strings has to be held closer to the base (e.g. Yamaha Pacifica 112). So it would be good to have at least one shorter version in the store. Important to mention, that unfortunately no other brand has this kind of option for a shorter roller string tree yet.

Cons
-Rolletjes zitten niet op een afzonderlijke as
Pros
goede afwerking, blijft afgestemd

Nicely made. No screws supplied but use the one from the string tree being replaced. They are a tad high so beware of this when replacing the cheap butterfly string trees. I reversed a couple on one guitar to bring the string height down further with the roller to the front.

I have ordered these string trees to replace the stock ones on my Harley Benton TE-70 Black Paisley. If you are considering the same - you should know the they are several milliliters higher in comparison to the ones installed. So the tension of the string is lower to the neck nut.
The quality is OK. Just make sure to measure and do not expect miracles :)

They are a cheap improvement over the bent steel ones. Tuning stability is improved although both strings roll on the same axe. It's not as big of a problem as I though it would be


They should come with the screw, as the original bent-steel screw was short, and I needed to find a screw elsewhere.