pro snake TPY 2003 BPP

Not much to say about it really, I bout this to split a stereo jack into two monos so I could connect it to an effects pedal. No issues whatsoever, length is also pretty much ideal for what I use it for.
Only (really nit-picky) feedback from my side would be that the connectors themselves have very long heads for such a short cable. If the inputs/outputs of your gear is all to the sides you're good to go, but if you have to pull a 90 degree angle with this cable, it won't look as professional as it could be. That being said, for this price range, it's more than ideal.

I have never actually tried other products (Higher quality/price)
But from my experience with these, I am satisfied. No latency or noise.
They can easily unscrew so I am constantly screwing them back on but appart from that they do their job perfectly :)

Tchuss

Sometimes Pro Snake hits the nail on the head, and this is one of those cases, for sure. It's well built, works, and looks good (that's important, right?). A simple tool to split stereo signal to two mono paths, and I use it a lot to run some simpler synths into a wet-dry signal chain. Good call if you need it, and I'd recommend it.

Does the job, good quality plugs. The only thing is that from time to time I had to tighten the screw on the connector as it gets a bit loose. But I've seen the same with some other screw-in metal jacks on my patch cables for example.

The input jack is a bit too loose for a use on tour. For an installation where the cables are not really under stress or never get touched, this should work. The quality is ok.

I needed these for my audio setup, would recommend to everyone!