Rockbag Fingerboard Saver 3 jumbo

Rubber should be better, stronger. Good overall.

Not much to say really..
The savers and pretty strong and made of good stainless steel.
I used them while recrowning guitar frets using a triangle file and they are barely scratched. If used with a crowning file I believe they would stay perfect and last a long long time.
The only thing I have against the system are the rubber bands.. although they are somewhat useful to get the fret saver to match the neck profile, I feel they wont last long due to the sharpness of the slots where they are to be attached.

Overall a very good product for luthier work.

Nothing wrong with this set. Just that it's for large jumbo frets which I later learned, my guitar wasn't. So I didn't use it, incase I'd file on the freboard inside the groove slot.

Not a "must-have" if you have a straight hand, but it helps to reduce stress if you going to work on frets of an expansive guitar. It also fits for medium frets.

Bought 1 of those pairs of fingerboard savers and they work well.

The rubbers are not very strong but words as expected. I only advise to use painters tape under the fingerboard saver on the side that is in contact with the fingerboard as it can wiggle a bit in the smaller frets and damage the fret board

A bit clumsy to work with. It tends to just fall off, and metal could be thinner, so you could have better access around the frets to work on them.