Rockboard Flat Looper/Switch Cable 40 cm

Great price for a great product. No signal loss. No stress. Just make sure you measure where your pedals are on your board to where you will put your loop switcher and count how many you're going to need. I will definitely be buying these again when I buy a new pedal behind my wife's back 😂 Very sturdy, and they look just as good as the one with the metal jack's.

Använder dessa för att koppla in mig till en pedalswitcher. Den vinklade kontakten funkar fint, men den raka har en väldigt irriterande egenskap: den har ett tjockt och oflexibelt skal som sticker ut ett par cm från själva kontakten, varför förstår jag inte. Resultatet blir att den tar upp onödigt med plats på pedalbordet vilket motverkar själva syftet med det hela. Knöligt om man har ont om plats. Den hade fungerat mycket bättre för mig om bägge anslutningarna varit av samma typ som den vinklade. Själva kabeln och kontakterna är av bra kvalitet dock.

I was building a compact little pedal board and needed some low-profile patch cables to save space. These seemed like a good choice. The angled jack is VERY flat and low profile, which saves A LOT of space between pedals. The cord itself is quite soft and easy to manipulate into position, which makes installation easier.
I used these Rockboard patch cables for all the connections within my board and have had zero issues with the setup whatsoever.
No noise. No loss of signal.
Highly recommended :-)

All Rockboard cables are really well built and sturdy. But their angled connectors have one small issue. The small plastic protrusion at the end may look pleasing design-wise, but functionally it makes it hard to place two connectors side by side in cramped pedalboards.

I recently took delivery of a new pedalboard loop switcher and MIDI controller. I have built my new pedalboard using these cables and the Rockboard flat and angled MIDI cables. They work a treat! I like how they save space on the pedalboard while at the same time plugging into a very tight array of jack sockets on the loop switcher. I have not detected any audio problems whatsoever.

A cable like this is a very setup-specific thing. Right now this is the main out cable from my pedalboard to my amps and I love it! Fits perfectly into my setup and doesn't flop around like most standard cables have done in my setup.

Easy to recommend - I'm really liking Rockboard equipment. Price/performance level is excellent

I used a couple of these cables to make my first pedalboard and I was very happy with the result. Quality is very good but a little bit flimsy. However, for that price I can't complain and it does its job quite well.

Better than EBS cables in my opinion

exactly what you'd imagine it is