Customer reviews about the t.bone SSM 6

T

Good but not great

TomislavK 28.08.2020

Why it is good? Well it will hold your microphone, but you should go and use it for ticker microphone on recommended values. I think it would work fine with 28mm to 40mm diameter microphones.

Why not great? Well my is Oktava is 23mm wide and it is also in recommended value as it is over 20mm, but it is not secure at all, together with cable it may work if you have your microphone at the same level as Flor, but if you want to tilt it you are risking that microphone pops out of this shock mount as it hold it very flimsy and i don like it.
I will probably have to do some modification to make it usable and more secure with 20mm to 28mm condenser.

7

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

C

How is it this cheap ?!

CyberDNIWE 06.06.2021

Comming from similarly priced chinese shock mount, this thing does amazing! Not only does it help with bump pickups when touching the stand, but it also seemed to isolate the bumps comming from the desk that my arm is mounted on.
The screw is wide enough and clamps easily, and the mechanism seems not to require lots of tension to keep in one place.

Build quality:
The outer ring is made out of metal that does not resonate with bumps and the outer rubber bands are thick and are covered in isolation (think: heavy duty hair bands).
The inner ring is hard(ish) plastic and the bands that actually hold the microphone are naked thinner soft "wet-ish" rubber.
The connector is made from thick plastic and the screw hole is made via copper insert.

Everything seems to be made to last, but the only concearn I have are the soft naked inner rubber bands, which might "dry out" after a while... but I guess that's why you get two spares in the box and I'm sure you can buy equivalent bands in any of your local hardware stores.

Conclusion:
If you need a shock mount: GET. THIS. NOW.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

T

TRLDEX 26.11.2020

It has a good fit on my AKG D5 S mic and all the noises coming from my desk were cancelled. Initially I was using a regular table mount with some rubber feet, but every time I was touching the desk I could see the VU-meters raising. These nasty noises have stopped since I got this shock-mount. For its price is very good indeed, definitely recommended.

The outer shock-mount is metallic (aluminum perhaps), so it is solid and should last.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

AI

Superb Quality item. Very reasonably priced. Thank you.

AN Ireland 24.01.2022

Versatile shock mount just try it to see how good it. I'm delighted I purchased this item and would have no hesitation in buying again if needs be.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

Mt

Great value

Mike the Drums 06.03.2014

Even though spec says max 40mm, this fits 52mm diameter mic (AT2020). The mic itself is held between the elastic cords, so it adapts very well to any mic size. Works very well, and costs next to nothing! Worth every penny.

7

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

PG

Do you mind replacing the rubbers?

Pietro G. 14.05.2018

If the answer is: no, then you will be ok. The frame is robust, metal. The rubbers are weak and will break in a short time. If you replace them with a good one you'll have a nice mount.
Ciao

1

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

j

Works as promised!

j0ng0m 09.06.2022

Using this shock mount with t.bone MB 60, they work great and the noise from the table doesn't transfer to the mic. Recommended.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

R

the t.bone SSM 6

Rezen 04.12.2020

Отличные держатели за свои деньги. В него помещаются не только микрофоны указанного диаметра, как к примеру мои Lewitt LCT040 но и более толстый RODE M3.

0

1

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

R

Handy to have kicking around the studio.

Robert487 11.05.2020

I bought this to have a more universal mic holder.

Pro's - This will accept most mic types and provides a pretty firm grip once the mic is in place.Very good value for money.
Con's - The build quality is good for light to medium use but i think that's reflected in the price.

I find myself reaching for this cradle every once in a while and i'm glad i have it.Good swiss army knife for your studio,large or small.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

EB

Surprisingly nice!

Edgar Blackdagger 07.06.2020

Seeing the photos I was expecting a regular sized plastic, e-bay grade shochmount, but it's in fact metal, big and sturdy!
Its size makes it useable for almost any mic, but it's especially good for handheld dynamics, it's the best mount for my Sontronics Solo.

I only have it for some weeks, so I don't know how it will become after a lot of use but for that price I recommend it without a doubt.

0

Report

Do you believe this rating to be inaccurate or unacceptable for some reason? Please give us the reason for your assessment in the following text box and – if possible – your e-mail address for further questions.

the t.bone SSM 6

818 Customer ratings

You have to be logged in to rate products.

401 Reviews

Served with love!

the t.bone SSM 6

818 Customer ratings

You have to be logged in to rate products.

401 Reviews