Harley Benton Humbucker Frame Screw Set N BK

I've seen other reviewers saying they expected bigger screws but these should fit most **shallow/flat** humbucker frames with no problem. Despite their size they were still able to get a good grip into the 3 ply pickguard on my guitar. Nice one HB.

I ordered these screws to go with Harley Benton's own pickup mounting rings but they looked really off as the screw heads are smaller than the holes on the pickup rings. The shorter screws are also even shorter than standard pickup ring screws so they barely go into the guitar.

Good for shallow humbucker frames, finish seems to resist corrosion, will go in if you turn them clockwise, and out if you turn them counter clockwise.

Useless - too short and too small. It's not even long enough to use for neck humbucker frame. It was a waste of money.

Guitar - Jackson King V with Floyd Rose

I get these purely for aesthetic reasons. The smaller flat top screws look so much better than the bigger dome headed screws. I use these on truss rod covers, humbucker frames, cover plates, and pickguards.

Can't use as they are thinner than original ones on Gibson, Dean and others US guitars

Threads are too thin for the CST-24 mounting holes, considerably smaller than the stock screws.

These worked just fine on the back side of my guitar to lock down my wiring plates.

Used these to replace broken humbucker rings on my Vintage v100 guitar.

These screws are incredibly tiny. They barely reached the wood of my guitars with stock pickup surrounds. That didn't help, because the diameter is so small that they can't grip the holes. When used with the Harley Benton pickup surrounds found on this site, they don't reach the body AT ALL.

Tried them on a Jackson JS32 and a Cort KX1 and neither of them worked at all. Disappointed.