Neutrik SCDR

Yep, work nicely on the back of a Neutrik speakon. Tough and plenty long enough for speakons and XLRs. Easy enough to slice off an entry hole for the cable (if required). The plastic is a good thickness, not some thin stuff that would tear easily.

Recommended to tidy up your installs at a reasonable price.

Very helpful to have a nice and tidy panel. Protect very well against dust and is definitely made for Neutrik equipment.
A bit expensive but still very good compared to other sellers.

The Neutrik SCDR plastic cover cap does exactly what it’s supposed to do – it protects connectors from dust, dirt, and damage when not in use. The fit is secure and snug without being difficult to remove.

The material feels durable and well-made, which is typical for Neutrik products. It’s a small and inexpensive accessory, but it helps extend the lifespan of connectors, especially in touring or live environments.

A practical addition to any setup where reliability and equipment protection matter.

I really like to have this on my DMX panel. It makes it clean and safe.
Strongly recommended to have one per panel connector

exactly what you'd imagine it is

Great to use with Neutrik NJ3 FP-6-C and made my Templeaudio due 24 very neat and tidy. :)

Cut the end to fit your cable through (cut smaller and push through rather than cut to size/cut larger)

Fits perfectly onto Neutrik panel connectors (and most others)

Good quality and protect the connector well