To the page content

the box Speaker 12-280/8-A

312

Speaker

  • Size: 12”
  • Power capacity: 280 W RMS
  • Impedance: 8 Ohm
  • Aluminium die casting
Available since June 2006
Item number 193263
Sales Unit 1 piece(s)
Impedance 8 Ohms
Load Capacity 280 W
759 kr
Including VAT; Excluding kr200 shipping
In stock
In stock

This product is in stock and can be shipped immediately.

Standard Delivery Times
1

312 Customer ratings

4.6 / 5

You have to be logged in to rate products.

Note: To prevent ratings from being based on hearsay, smattering or surreptitious advertising we only allow ratings from real users on our website, who have bought the equipment from us.

After logging in you will also find all items you can rate under rate products in the customer centre.

sound

quality

168 Reviews

R
12-280/8-A
Robert814 04.04.2019
The construction of these speakers is impressive: die-cast chassis, solid and sturdy without being uncomfortably heavy. Big ceramic magnets. A large perforated ventilation grille in the centre at the back which literally pumps cooling air around the voice coil - no wonder they are claimed to handle 280 Watts !
The box 12-280-8-A are quite rightly categorised as PA speakers. I intend to use them as Guitar speakers ! This is simply because I cannot find any others with a frequency response that is wide ranging and (most importantly) NOT with any kind of peak or boost in the range 2.9-3.9 kHz. It has been an almost impossible quest to find any guitar speakers that meet this requirement. Almost all begin to peak in output somewhere above 2kHz and usually above 6dB higher than the average output. The 12-280-8-A has a 5dB reduction in output level between 3k-4.2kHz instead of the usual increase. The12-280-8-W by contrast has a narrow 5dB peak at 2.8 kHz and then drops off by 20dB at 3kHz. Fine with a crossover as intended for PA but not really suitable for guitar. The A type is good up to about 4kHz where it drops right down off scale. This is pretty close to what I'm looking for. If after testing for some time with lead guitar I get to notice the lack of high harmonics, then I may try adding a piezo horn with resistive attenuator (because this isn't a PA). The other requirement I've had trouble finding is a solid low frequency response (for lead guitar). Some other reviewers have mentioned speakers needing to be "Broken in" until the low frequency response increases. I've given up on this after about a year with an otherwise excellent 12 inch speaker. It just lacks that little bit of low response. By comparison, the 10 inch speaker in my Pro-Junior has a much more potent bass response than the 12 inch - weird ! So far THIS 12 inch is proving to give just the kind of sound I was hoping for with lead guitar. I'm well pleased !
sound
quality
7
3
Report

Report

A
Nice low mid driver!
Anonymous 10.05.2016
I use this driver in a diy bass reflex enclosure, crossed @90Hz-2500Hz.

Power is enough for my use, the quality of the frame is outstanding for the price : nice solid casted aluminium. The spring connections is also a plus.

Sound is good until quite high, so no trouble to use with 1" compression drivers.

One slight downside : the screw holes are very close to the baffle cutout, in my case I did some extra routing to ensure a secure fastening to the enclosure.

Overall very nice driver, good sound and build quality, killer price. Thomann delivery etc = 5 stars as usual...
sound
quality
3
0
Report

Report

i
Good!
ivan90stop 28.02.2022
I bought this speaker to replace it with an old one that broke down.
At the first hearing, I was surprised. Sharp treble that doesn't bother listening, defined bass. All in all, a worthwhile purchase. The price-quality ratio is really good, for that sound quality it might take more.
sound
quality
1
0
Report

Report

y
yoon 15.02.2019
gut ist das Rendern und Erfüllen
sound
quality
0
0
Report

Report