To the page content

Hicon HI-J63SA05 Angled Jack

152

Angled jack

  • Extremely flat 6.3 mm angle jack
  • Stereo
  • For cable diameters from 4.0 - 6.4 mm
  • Especially suitable for floor effects
Available since December 2015
Item number 377803
Sales Unit 1 piece(s)
Installation No
Mono/Stereo Stereo
Angled Yes
Type TRS (stereo/sym.)
Plug Jack 6,3 mm TRS male angled
37 kr
Including VAT; Excluding kr200 shipping
In stock
In stock

This product is in stock and can be shipped immediately.

Standard Delivery Times
1

152 Customer ratings

4.4 / 5

You have to be logged in to rate products.

Note: To prevent ratings from being based on hearsay, smattering or surreptitious advertising we only allow ratings from real users on our website, who have bought the equipment from us.

After logging in you will also find all items you can rate under rate products in the customer centre.

quality

89 Reviews

t
ground contact is missing
t3hh 23.03.2022
contact for soldering the ground wire is missing. The best solution would be soldering the ground into the nickel plated case but this is somewhat complicated process. You need to use acid based active flux (rosin based flux wont work) and more powerful iron. Don't forget to clean the flux after the soldering, it contains acid and will corrode. Some people leave the ground wire unsoldered and use the pressure to make a ground connection but this can not be suggested for critical audio work.
quality
2
0
Report

Report

d
Can’t recommend
daTroll 09.05.2021
Only get this if you have no other choice, e.g. if the space is limited. There is no solder lug for the sleeve/shield, so you either try to solder it anyway or just let the shield get crimped when you screw the plug pieces together. Another big problem is quality. One of the plugs I bought wasn’t manufactured correctly in that the tip was loose and could be rotated together with its solder lug. O_o
quality
1
0
Report

Report

BE
Quality good but design not so
Bo E. 04.05.2016
For all my patch cables I use the mono variant and couldn't be happier! The stereo ones however... You have two solderpoints, one L and one R but the earth has no real soldering contact and has to be pressed against the enclosure of the jack to make contact... which fails eventually... I swear by the mono ones for all my patch cables but the stereo is not recommended !
quality
2
1
Report

Report

R
Needed this one
Recorick 08.06.2024
I got these for tap tempo on my delay, I needed 90 degrees for tight fitting on my pedalboard.
quality
0
0
Report

Report